UniLight Direct Connector (6 primary poles)
The innovative uniCONNECT plug-in system works with massive knife and highly resilient skirting boards. Thanks to the new design, high numbers of poles can finally be realized in a connector with a small size – currently up to 22 pins. For this purpose, more than 3000 mating cycles are possible at loads up to 10A. Optimally realized for use with model making.
The knife strips offer the advantage that all cables can be soldered reliably and easily without melting a plastic carrier. In addition, there is strain relief, latching, handle and kink protection. The contacts of the knife strips are always visible, which means that damage and contamination can be seen immediately.
The biggest advantage of the system, however, is that double redundancy for important control functions is already provided in the plug. For this reason, the system not only specifies conventional pin numbers, but also distinguishes between primary pins (double, for main functions) and secondary pins (single, for light, chassis, brake,...).
Floating DIRECT & Floating HEADER are two groups of plug-in systems developed exclusively for the independent contacting of the wing and fuselage. There are no cables and plugs hanging around that can be damaged or dirty. The knife strip is contacted directly with the socket during assembly. This is reliably possible with uniCONNECT because the bushing strips are not rigidly but "floating" connected to the carrier and can therefore move with slight movements and vibrations of the wings. Of course, the system is only suitable for rigidly screwed, right-angled and cleanly guided connections. The plugs cannot absorb mechanical stress from an inaccurate plug!
The two groups DIRECT and HEADER differ only in the connection. DIRECT was primarily developed for reliable solder connections, HEADER is prepared with normal pins for uni connectors.
All connectors are screwed together from several high-quality glass fiber elements and can be dismantled and maintained at any time. For this purpose, each connector is offered in two versions:
RTR as a fully assembled and soldered unit with 2/3m cable directly connected 1 to 1. This is installed on one side, the length of the servo is defined and assembled with crimp contacts. The remaining cable is laid on the other side to the receiver and assembled there. This finished unit is always delivered in one piece.
DIY as a kit for the model maker with all individual parts and screws for your own construction. As a result, of course, very attractively priced, always delivered as a pair of 2 pieces.
- 6 primary contacts (redundantly guided; for main functions such as servos)
- 3000 mating cycles,10A
- Strain relief, handle and kink protection
- Primary Contacts
- Redundancy already in the plug
- Easily accessible contacts and solder joints
- Self-contacting in floating design
- Fully assembled with 2m cable (0.25mm²) or
- As a kit with all parts and screws
- Built-in template included
- Dimension aperture 15x35mm
- Plug weight 10g without cable