Unilight 10,24mm ROUND Strobe Light, 8W
Red 8W point light with two transparent polycarbonate caps (10mm and 24mm). The module is delivered completely wired-up on an aluminium retaining plate for cooling and mounting. Another small heatsink for an alternative mounting with the smallest dimensions is included. In case of longer operation, please pay particular attention to the temperatures. With the 8W module, we recommend the usage of a cooling plate AND heatsink.
You only have to glue on the desired cap and heatsink with superglue. The 10mm cap serves as light distribution concerning the concealed installation behind a GFK wall. The 24mm cap can be used for external installation for it completely covers the module. The accessory includes a profile expansion in polycarbonate, which can be optionally glued on the 10mm cap.
Technical Data:
Electricity: 8W reference power, 8(12)V, 0.7A
Beam angle: >160°
Light intensity: ~90 Lumen RED
Light intensity: ~150 Lumen GREEN
Light intensity: ~200 Lumen WHITE
Dimension base plate: 20x50mm
Dimension additional heatsink: 15x15x6mm, self-adhesive
Small cap: D10x12mm + profile expansion
Big cap: D24x10mm
Weight: 8g (without cable)
The reference power is a comparison value between our offered lights. It normally refers to an operating voltage of 12V/3S Lipo and is dependent on bulbs, operating mode and technology.
The luminaire is ready to use for operation with 2S LiPo (ca. 8V). With 3S (12V), the enclosed resistor has to be added. Please note that high-performance LEDs can get very hot, up to 70°C is quite normal. These lamps with heatsink cases are suitable for continuous operation if an air flow (during flight) is possible. If this is not the case, the duty cycle of 5-10 minutes should not be exceeded. Pay always attention to the operating temperature, we do not assume any warranty in case of overheating.
Note: The LED lights are extremely bright! Never look directly into a LED!